Flow 007303-2 Aftermarket 60K Intensifier End Bell, Left Hand

Flow 007303-2 is the left hand high pressure end bell (end cap) of the 60K intensifier, which holds the high pressure cylinder and the check valve. It is used on Flow 60K intensifier pumps. This aftermarket version is made to the same mounting and connections as the original, so it fits where the old one came off.

The same part is also sold as AccuStream 1-11433.

Sold as one unit. Check the number on your old part, or in the parts manual for your machine, before ordering.

Technical Properties & Sizes

Applications & Use Cases

Leaks at the end bell
Water at the end bell weep holes means a seal or the sealing face is worn. A sealing face that has been cut by leaking water cannot be trusted and the end bell needs replacing.

Cracks
End bells see full intensifier pressure on every stroke. Any crack, however small, means the part must be replaced before it fails in service.

Pump rebuilds
Replace a damaged end bell during a major rebuild rather than reusing it with new seals.

Fitting tips
Isolate power and bleed the high pressure first. Clean every sealing face, use the maker's lubricant on the threads, tighten the tie rods in sequence to the maker's torque and check for leaks at low pressure before cutting. This is the left hand end bell; check the side before ordering.

Price Beat Guarantee

We check what other aftermarket sellers charge for this same part. Their prices on the date we checked:

Our price of USD 353.60 is 20% to 78% less than these sellers.

Found this part cheaper somewhere else? Send us the listing and we will beat it by 5% under our Price Beat Guarantee. Every order is also covered by our 30 day money back guarantee.

Frequently Asked Questions